Abrasion Resistance of Shotcreted Low Cement Castable at Elevated Temperatures
Süperates¸ Refractory Inc., 34398, Istanbul/Maslak/Turkey
Revision
Volume 5, Issue 4, Pages 89 - 92
Abstract
Refractory gunning is a very common method especially in construction and hot/cold repair applications. Conventional dry gunning has high application areas because of the easy installation and low labor cost. Shotcreting (concrete gunning, spray cast) methods have high potential to overcome low erosion resistance of conventional dry gunning methods. In this work, the physical, mechanical and abrasion/ erosion properties of gunning materials produced by dry and wet gunning methods were investigated. The abrasion properties were investigated at high temperatures (25 – 800 – 1200 °C). The blast abrasion properties of shotcreted material have very low wear loss compared to conventional gunning methods.
Keywords
shotcrete, dry gunning, blast abrasion, low cement castable
References
[1] Adamiak, M.: Abrasion resistance of materials. Published by InTech, Croatia, 2012 [2] Grdic, Z.J.; et al.: Abrasion resistance of con crete micro-reinforced with polypropylene fibers. Construction and Building Materials 27 (2012) [1] 305–312 [3] Liu, Y.W.; Yen, T., Hsu, T.H.: Abrasion erosion of concrete by water-borne sand. Cement and Concrete Research 36 (2006) [10] 1814–1820 [4] Denisov, D.E.; et al.: Refractories in heat units. Abrasion resistance of refractory concretes and linings. Refractories and Industrial Ceramics 48 (2007) [1] 4–8 [5] Simmat, R.; et al.: High temperature abrasion resistance of refractory products. 10th Biennial Worldwide Conf. on Unified Int. Technical Conf. Refractories (UNITECR), Dresden/DE, 2007, 514–517 [6] Ntakaburimvo, N.; Allaire, C.: Abrasion wear of alumina silicate refractories. Advances in Refractories for the Metallurgical Industries IV, CIM Proc., ed. by M. Rigaud and C. Allaire, August 2004, 373–388 [7] Denisov, D.E.; et al.: Refractories in heat units. Abrasion resistance of refractory concretes and linings. Refractories and Industrial Ceramics 48 (2007) [1] 4–8 [8] Peng, X.; et al.: Research on abrasive resistance of several kinds of refractory products et ele vated temperature. 11th Biennial World - wide Conf. on Unified Int. Technical Conf. Refractories (UNITECR), Salvador/BR, 2009, Vol. 1 of 2, 34 [9] Peng, H.; Myhre, B.: High temperature properties of bauxite based castables with microsilica. 51th Int. Coll. on Refractories, Aachen/DE, 2006
Copyright
Göller Verlag GmbH
